3/12/2023 0 Comments Briggs and stratton manual 20 hp![]() Note: The number 1 on #1 connecting rod and the number 2 on #2 connecting rod must be facing PTO side. Rod should also be free to move sideways on crankpin. Rotate crankshaft two revolutions to check for binding. ![]() ![]() Assemble connecting rod cap to rod with match marks aligned, Fig. Push piston down by hand until connecting rod is seated on crankpin.įig. Install #1 piston with arrow towards flywheel side, Fig. Lubricate cylinder bores and crankpin and rotate crankshaft until it as at bottom of stroke. Then loosen ring compressor very slightly so that compressor can be rotated on piston skirt while holding connecting rod, Fig. Tighten ring compressor evenly until rings are fully compressed. Place piston and ring compressor upside down on bench with projections on compressor facing up. Oil piston rings, piston skirt, and compress rings with Ring Compressor Tool #19070, Fig. Note: Install #1 piston and connecting rod first. ![]() Lubricate mag bearing and lips of oil seal with engine oil and install crankshaft.ĮNGINE ASSEMBLY Install Piston & Connecting Rod V-Twin Cylinder OHV Engine Service Manual Version 1.0 Copyright© 1999 by Briggs and Stratton Corporation
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |